Ricon 70-100 Manuel de l'opérateur télécharger pdf (Page 11)

ASSEMBLY

Secure The Lathe to a Solid Work

Surface

The lathe must be attached to a solid work

surface or stand. Four mounting holes are easily

accessible at the each end of the lathe’s base.

FIG. 12.

NOTE: Mounting screws or bolts are not

provided.

ADJUSTMENTS

Adjusting the Tool Rest

The tool rest base can be easily moved along

the lathe bed. Loosen the locking lever counter

clockwise, slide tool rest base to a new position,

and then re-tighten the locking lever, clockwise.

To adjust the height of the tool rest, loosen the

locking arm, raise or lower tool rest, then

re-tighten the locking arm. FIG. 13.

Note: Position the tool rest as close to the work

piece as possible. It should be 1/8” above the

center line of the work piece.

Tool rest

Locking arm

Locking lever

Tool rest base

FIG. 12

Mounting holes

Install The Tool Holder

Located the plastic tool holder from the carton,

and install it onto the lathe bed with two pan head

screws. FIG. 11.

Pan head screw

Install The Faceplate on the Headstock

1. Thread the faceplate clockwise onto the

headstock spindle.

2. Next, engage the spindle lock and stop

the spindle from turning, and then tighten the

faceplate in place with the supplied wrench.

FIG. 10.

FIG. 10

Faceplate

Spindle lock

Warning: Disengage the spindle lock before

turning the machine on, or damage to the

machine may result.

FIG. 11

FIG. 13

Tool holder

NOTE: To adjust the clamping action of the tool

rest base, or the tailstock, adjust the locking nut -

turn it clockwise to tighten, and counterclockwise

to loosen. See FIG. 3 and instructions on page 9.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ricon 70-100 Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Tours Ricon 70-100