Ricon 70-100 Manuel du propriétaire télécharger pdf (Page 8)

8 Fig.11

Secure Lathe to a Solid Work Surface

The lathe must be attached to a solid work surface

or stand. Four mounting holes are easily

accessible at the base of the lathe. (See Fig.09)

Adjustments and Operations

Adjusting the Tool Rest

The tool rest base can be easily moved along the

lathe bed. Loosen locking lever counter clockwise,

slide tool rest base to new position, and tighten

locking lever clockwise.

To adjust the height of the tool rest, loosen locking

arm, raise or lower tool rest, tighten locking arm.

(See Fig.10)

Note: Position the tool rest as close to the work

piece as possible. It should be 1/8” above the

centerline of the workpiece.

To adjust clamping action of the tool rest base,

remove base and adjust nut clockwise to tighten

and counterclockwise to loosen.(See Fig.11)

Tool rest

Locking arm

Locking lever

Tool rest base

Locking arm

Locking lever

Tool rest base

Fig.09

Mounting holes

Installing Tool Holder On the Lathe

Bed

Located the tool holder from the carton, and install

it onto the lathe bed with two pan head screws.

(See Fig.08)

Pan head screw

Installing The Faceplate to the

Headstock

Thread the faceplate clockwise on to the

headstock spindle. Next, engage the spindle lock

and stop the spindle from turning, and tighten

faceplate with supplied wrench. (See Fig.07)

Fig.07

Faceplate

Spindle lock

Warning: Disengage spindle lock before turning

the machine on.

Fig.08

Fig.10

Tool holder

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

Ricon 70-100 Manuel du propriétaire Page 8

Commentaires sur ces manuels