Ricon 70-100 Manuel du propriétaire télécharger pdf (Page 9)

Adjusting Tailstock

Loosen locking lever to move the tailstock along

the lathe bed to desired position. Tighten lever.

To adjust clamping action of the tailstock, remove it

from lathe bed and adjust nut clockwise to tighten

and counterclockwise to loosen.(See Fig.12)

To adjust tailstock arm in or out, loosen locking

arm and turn handwheel. When the tailstock arm is

in a desired position, tighten locking arm.

(See Fig.13)

The tailstock arm will travel from 0” to 2-1/2”

Locking arm

Locking lever

Handwheel

Tailstock arm

Nut

Changing Spindle Speeds

The lathe features a six step motor and spindle

pulleys to provide different spindle speeds. Open

access cover to change spindle speeds.

(See Fig.14)

With access cover open, loosen locking arm.

Raise lever to release tension on motor pulley and

tighten locking arm. Check speed and belt position

chart inside access cover to determine spindle

speed required.

Move drive belt to desired pulley combination.

Loosen locking arm, lower lever, and the motor will

provide proper tension on the drive belt. Tighten

locking arm and close access cover. (See Fig.14)

Access cover

Belt position Chart

Locking arm

Tension lever

Typical Operations

The lathe is set up for a typical spindle turning

operation.(See Fig.15)

Fig.12

Fig.13

Fig.14

Fig.15

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Ricon 70-100 Manuel du propriétaire Page 9